| M10 nut on connecting link, a/f 18 |
Wheel carrier |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Control arm 2 (toe control arm) to wheel carrier (taper), M12 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
75 Nm (56 ftlb.) |
|
|
| Control arm (lower control arm) to wheel carrier (taper), M12 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
75 Nm (56 ftlb.) |
|
|
| Drive shaft to transmission M10 (manual transmission) |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
81 Nm (60 ftlb.) |
|
|
| Brake hose bracket to wheel bearing housing, M6 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Brake calliper threaded connection to front and rear axle, M12 x 1.5 |
Replace bolts on front and rear axle following removal. |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Combination wire to wheel carrier, M6 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Drive shaft to wheel hub, M22 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color! Replace lock nut following removal. |
Tightening torque |
460 Nm (340 ftlb.) |
|
|