LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2008 >> Cayman Base, Automatic >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> 9X - Electrical System - General -- 987-BOXSTER-CAYMAN >> WM 9X00IN Optical WAVEGUIDE - Most Bus (All Models) >> Optical Waveguide - Most Bus >> Removing And Installing Optical Contacts On Socket Side

Removing And Installing Optical Contacts On Socket Side

  1. Release the spring cap on both sides using the press-out and unlocking tools for tab and round plug connectors of all sizes Nr.155  and remove it.
    Fig 1: Unlocking Spring Cap Of Optical Contacts (On Socket Side)
    G09593076Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Remove optical waveguide module from connector.
  3. Position the press-out and unlocking tools for flat-type and round plug connectors of all sizes Nr.155  for releasing the contact locking mechanism of the optical waveguide module and lift up the locking mechanism.
    1. Optical contact, grey
    2. Optical contact, black
    Fig 2: Removing Optical Waveguide Module From Connector
    G09593077Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Carefully pull on the optical waveguide -A and B-  in -arrowrichtung-  . If it is not possible to pull out the optical waveguide, check again if the locking mechanism is completely released.

    Perform visual inspection of locking mechanisms, connector housings and contacts for possible damage, and exchange the damaged parts, if necessary.

scientia non olet · About LEMON Manuals