Installing Optical Contacts On Socket Side

Remove the dust boot right before plugging.

Check the proper condition of the contact.

At a force of 10 N (7.5 lb.) the springs installed in the connection point will be compressed. This leads to an increase in attenuation, which could lead to system impairment and system failure. Therefore a maximum force of 10 N (7.5 lb.) may be used to pull on optical waveguides at connection points.

1. Insert optical contact -B-  into the optical waveguide module until it is felt to engage, and check the optical contact is seated securely.
   1. Optical contact, grey
   2. Optical contact, black
   Fig 1: Inserting Optical Contact Into Optical Waveguide Module
   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Insert optical waveguide module into the connection point on the socket side.
3. Slide the spring cap on the connection point until it can be felt to engage -arrow-  .
   Fig 2: Inserting Optical Waveguide Module Into Connection Point On Socket Side

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.