Installing Hydraulic Pump (Cayenne V6)

Information 

• Only use Pentosin CHF 202 to fill the hydraulic system. 
• Pay attention to the hydraulic fluid level. 
• Replace sealing rings. 
• Use correct tightening torques  → WM 4300TW TIGHTENING TORQUES
• Use correct tightening torques →  Tightening Torques  

1. Fit the hydraulic pump. → Tightening torque: 23 Nm (17 ft lbs.) 
2. Fit pulley on the hydraulic pump and screw in the screws.
3. Fit drive belt in correct position and tension Checking drive belt .
4. Tighten the pulley on hydraulic pump. → Tightening torque: 23 Nm (17 ft lbs.) 
5. Fit both hydraulic lines. → Tightening torque: 30 Nm (22 ft lbs.)+/-3 Nm (+/-2.0 ft lbs.)  → Tightening torque: 10 Nm (7.5 ft lbs.)  Remove hose clamp 3094.