Removing B-Pillar Trim Panel
Information
- In order to reduce the unclipping forces and thereby the risk of damage during removal, the process must take place at the accessible connection points using a suitable tool.
- Remove bottom seat belt mount cover.
- 1.1. Unclip cover of seat belt mount -2- on seat and remove it.
- Loosen bottom seat belt mount.
- 2.1. Lift spring clamp -3a- .
- 2.2. Guide seat belt mount -3- down and unhook it.
- Unscrew fastening screw.
- 3.1. Using a screwdriver, unclip cap -4- from B-pillar trim.
- 3.2. Unscrew fastening screw -5- .
- Unhook B-pillar trim at front.
- 4.1. Unhook trim for B-pillar -1- at front edge on deformation element (-arrows A- ).
- Unhook B-pillar trim at rear.
- 5.1. Unhook trim for B-pillar -1- at rear edge (-arrow B- ).
- Unclip B-pillar trim.
- 6.1. Unclip trim for B-pillar from the interior B-pillar at the bottom at the marked areas. To do so, raise trim slightly and lever out the clip connection using a screwdriver.
- Remove air vents.
- 7.1. Release plug connection -6- (-Arrow C- ) and disconnect it (-Arrows D- ).
- 7.2. Unclip air vent -7- on the B-pillar trim -1- and remove it. Whilst doing this, pull it out of the air guide -8- .
- Remove B-pillar trim.
- 8.1. Guide seat belt mount -3- through slide of B-pillar trim -1- .
- 8.2. Remove B-pillar trim -1- .