Tools And Materials: Tools

Information

It is best to use a tool that has an head height of less than 50 mm -A- (see SPECIAL TOOLS ) to loosen and tighten the rear fastening screw of the cylinder head cover close to the plenum panel.

Fig 1: Identifying Tool Height

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fig 2: Identifying Special Tools

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Item	Designation	Explanation
-A-	Centring sleeve 9701	Not absolutely necessary
-B-	Torque wrench 90
-C-	Socket change-over ratchet, 1/4 inch
-D-	Socket insert wrench (a/f 13), 1/4 inch
-E-	T40 inner hexagon socket bit

Information