Removing Engine Mounting

→ Secure components to prevent them from falling down.

1. Disconnect the battery.
2. Remove the heat protection plate on the generator for the engine mounting on cylinder bank 1 to 4. To do this, remove two screws. -arrows rechts- 
   Fig 1: Locating Heat Protection Plates

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Loosen the engine mountings. To do this, loosen the fastening nuts on the brackets and remove the engine mountings. → Left bracket for auxiliary units and engine mounting → Right bracket for auxiliary units and engine mounting
   Fig 2: Exploded View Of Left Bracket For Auxiliary Units And Engine Mounting

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. Bracket for auxiliary units/engine mounting
   2. Screw, M10 x 45
   3. Hydraulic mount, left
   4. Engine carrier
   5. Screw, M10 x 65
   6. Dowel sleeve
   7. Nut, M12 x 1.5
      Fig 3: Exploded View Of Right Bracket For Auxiliary Units And Engine Mounting

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. Bracket for cylinders 1 to 4
   2. Screw, M10 x 45
   3. Hydraulic mount, right
   4. Engine carrier
   5. Screw, M10 x 65
   6. Nut, M12 x 1.5
   7. Bores for screws, M10 x 45
   1. Installation view of engine carrier on crankcase