| Engine carrier to body |
M14 x 1.5 x 100 thread (replace screw) |
Initial tightening |
120 Nm (89 ft lbs.) |
|
|
| Engine carrier to body |
M14 x 1.5 x 100 thread |
Final tightening - torque angle |
180° |
|
|
| Transmission cross member to body |
Replace screws |
Initial tightening |
50 Nm (37 ft lbs.) |
|
|
| Transmission cross member to body |
|
Final tightening - torque angle |
90° |
|
|
| Heat shield on steering gear |
M6 x 16 thread |
Tightening torque |
10 Nm (7.5 ft lbs.) |
|
|
| Ground point of generator to side member |
M8 thread |
Tightening torque |
20 Nm (15 ft lbs.) |
|
|
| Catalytic converter holder to body |
|
Tightening torque |
23 Nm (17 ft lbs.) |
|
|
| B+ transfer point |
M8 thread |
Tightening torque |
23 Nm (17 ft lbs.) |
|
|
| Fuel supply line |
M16 x 1.5 thread |
Tightening torque |
35 Nm (26 ft lbs.) |
|
|
| Torque support to engine |
M10 x 85 thread (replace lock nut) |
Tightening torque |
60 Nm (44 ft lbs.) |
|
|
| Torque support to body |
M10 x 70 thread |
Tightening torque |
60 Nm (44 ft lbs.) |
|
|
| Ground point from control unit |
M6 thread |
Tightening torque |
10 Nm (7.5 ft lbs.) |
|
|