LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2008 >> Cayenne Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> 26 - Exhaust System >> WM 261019 Removing And Installing Exhaust Manifold On V6 DFI Engines (Cayenne Tip, Cayenne Man) >> Removing Exhaust Manifold

Removing Exhaust Manifold

  1. Remove heat protection panel.
    Fig 1: Identifying Heat Protection Panel Mounting
    G09410204Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. Fastening screws
    2. Holder
    3. Heat protection panel
    1. 1.1. Loosen the fastening screws -1-  .
    2. 1.2. Remove the holder -2-  and then remove the heat protection panel -3-  .
    3. 1.3. Unclip oxygen sensor cable on the heat protection panel.
  2. Remove exhaust manifold.
    Fig 2: Identifying Exhaust Manifold Related Components
    G09410205Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. Exhaust manifold
    2. Primary catalytic converter
    3. Fastening nuts
    1. 2.1. Unscrew all fastening nuts between the primary catalytic converter and exhaust manifold.
    2. 2.2. Push the primary catalytic converter to one side.
    3. 2.3. Remove all fastening screws on the exhaust manifold.
    4. 2.4. Remove exhaust manifold from studs on the cylinder head.
scientia non olet · About LEMON Manuals