Removing Sealing Ring For Transfer Gear Input Shaft

→ Drive bevelled attachment in by approx. 2 mm.

→ Screw sheetmetal screw max. two turns into the sealing ring.

1. Using the bevelled attachment from the slide hammer kit 168  , make a small hole -figure-  in the sealing ring.
   Fig 1: Making Small Hole In Sealing Ring

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Screw a suitable sheetmetal screw in by two turns.
   Fig 2: Screwing In Sheetmetal Screw

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Remove sealing ring using special tool slide hammer kit 168. 
   Fig 3: Removing Sealing Ring

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.