Installing Seal For Inner Roof Assembly

Fig 1: Identifying Installation Position Of Inner Seal For Roof Assembly

G09411592

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Open roof assembly completely.
Position inner seal.
1. 2.1. First push inner seal -1- under the fixed roof panel -arrow A- and then position the inner seal -1- exactly starting from the front.
2. 2.2. Align the inner seal -1- at the front edge flush with the seal -2- (-arrow B-) and press it against the contour of the roof assembly -3- over its entire length -arrow C- .
  
  Fig 2: Positioning Seal
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Information

Pull off protective film from the adhesive tape in sections and at the same time press the seal onto the roof assembly with the help of another person.
Stick on inner seal.
1. 3.1. Carefully lift the front end of the inner seal -1- (-arrow A-) and pull the protective film on the adhesive tape out backwards under the inner seal -1- (-arrow B-) .
2. 3.2. Press inner seal -1- down firmly on the roof assembly -2> (-arrows C-) .
3. 3.3. Move roof panel 3 into ventilation position.
4. 3.4. Pull protective film on the adhesive tape out backwards under the inner seal -1- (-arrow B-) .
5. 3.5. Press inner seal -1- down firmly on the roof assembly -arrows C- .
  
  Fig 3: Sticking On Inner Seal
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.