Protective Measures And Rules Of Behaviour

Information 

• Assembly work only by trained staff. 
• Carry out tests only with the Porsche System Tester diagnostic module; do not use test lamps, voltmeters or ohmmeters. 
• Do not bring into contact with grease, solvents, cleaning agents, or liquids. 
• Do not expose to temperatures above 90°C. 
• Keep the unfolding area of the airbag clear; e.g. do not hang test devices over the steering wheel. When carrying, hold the airbag with the blow-out direction facing away from the body. Store the unit with the airbag facing upwards. 
• Electrostatic charge: In general, suitable work clothing and footwear are to be worn. →  Tools And Materials  
• Do not remove the short-circuit spring of the plug contacts. 
• Never connect airbag units to electrical power sources not in accordance with regulations (danger of immediate ignition). Only use testers prescribed by the manufacturer. →  690101 AIRBAG DIAGNOSIS  . 
• During installation/removal or work on the vehicle involving vibrations: switch off ignition, disconnect and cover the negative terminal of the battery, wait 1 minute and only then disconnect the plug connection. 
• Transport: in transport packaging. Forbidden in passenger compartment! 
• Storage in the workshop: max. 10 kg (=> 100 driver's or 50 passenger's airbags); protect against theft! 
• The installation of the airbag/belt tensioner unit must be carried out immediately after removal from the transport container. 
• If work is interrupted, the airbag/belt tensioner unit must be stored in the transport container again. 
• Leaving the belt tensioner unit unsupervised is not permitted.