| B-pillar, bottom |
The B-pillar and B-pillar reinforcement are cut through completely during the cutting process |
Cut dimension, old part |
145 mm |
|
|
| B-pillar, top |
The B-pillar and B-pillar reinforcement are cut through completely during the cutting process |
Cut dimension, old part |
120 mm |
|
|
| Outer B-pillar, dimension X3 |
|
Cut dimension, old part |
35 mm |
|
|
| Outer B-pillar, dimension X4 |
|
Cut dimension, old part |
180 mm |
|
|
| Outer B-pillar, dimension X5 |
|
Cut dimension, old part |
160 mm |
|
|
| B-pillar, top |
Only the B-pillar must be cut during the cutting process. |
Cut dimension, old part |
40 mm |
|
|
| A-pillar |
The centre of the hole for the upper door hinge mounting on the A-pillar is used as the reference line for taking dimensions. |
Cut dimension, new part |
110 mm |
|
|
| A-pillar |
|
Overlap |
50 mm |
|
|
| C-pillar |
|
Overlap |
50 mm |
|
|
| Front side section, dimension X11 |
|
Cut dimension, new part |
20 mm |
|
|
| Front side section, dimension X12 |
|
Cut dimension, new part |
230 mm |
|
|
| Front side section, dimension X13 |
|
Cut dimension, new part |
210 mm |
|
|
| Side cuts |
|
Overlap |
50 mm |
|
|
| Top cut |
|
Overlap |
30 mm |
|
|
| B-pillar, top |
|
Cut dimension, new part |
44 mm |
|
|
| Seals |
|
Application depth |
10 mm |
|
|
| Seals |
|
Application depth |
10 mm |
|
|
| Seals |
|
Application depth |
10 mm |
|
|
| Seals |
|
Application depth |
10 mm |
|
|
| Seals |
|
Application depth |
10 mm |
|
|
| Body structure adhesion |
|
Application depth |
6 mm |
|
|
| Wing fastening rail |
|
Overlap |
50 mm |
|
|