Teaching Additional/Telephone Handset
CAUTION:
Voltage drop
- Risk of damage to control unit
- Fault entries in the control unit
- Coding in the control unit is aborted
- Malfunctions in control unit, even during programming
→ Ensure that the power supply is not interrupted during programming.
→ Connect a battery charger with a current rating of at least → Nominal value: 40 A to the vehicle battery. Information
Later versions of the software may display slightly different text or require a slightly different procedure. The instructions you receive from the Tester itself take precedence over this description.
- PIWIS Tester 9718 must be connected to the vehicle before starting the System Tester. Switch on ignition. Press [>>] to continue.
- Select vehicle type. Press [>>] to continue.
- Select PCM menu and press [>>].
- Engage telephone handset in the charging cradle.
- Select Handset menu and press [>>].
- Select Special function menu and press [>>].
- Select Teach handset menu and press [>>].
- Start teaching the handset by pressing [F8].
- Follow the instructions on the Tester. The message Handset has been taught must appear. Press [<<] to go back.
- Exit the Teach handset, Special function and PCM menu.
- Check the function of the handset.