Installing Belt Pulley - Engine Installed
Information
Degrease the belt pulley before installation on the flange side of the crankshaft using solvent naphtha or acetone.
- Position belt pulley on crankshaft flange (dowel pin).
Information
Replace belt pulley fastening screw.
Information
To release and tighten the belt pulley, a second person must counter with the relevant retaining tool.
- Insert fastening screw and tighten in two stages. Counter at the same time with special tool retaining device 9593 . → Tightening torque: 37 ftlb. ; → Torque angle: 90° ;