Installing Water Drip Pan: Overview

Fig 1: Identifying Installation Position Of Water Drip Pan

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Insert water drip pan -1- behind the convertible top support -2- from below -arrows- .
Position water drip pan -1- on the roll-over bar and press onto the two strips of double-sided adhesive tape -3- close to the fastening for the convertible top support.

Fig 2: Installing Water Drip Pan
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
NOTE:
Incorrect handling of tools
- Risk of damage to the body
→ Only use tools approved by Porsche.

→ Always ensure that the tool is seated correctly.

→ Protect the body and interior of the vehicle from damage with protective covers.

→ Cover delicate components with cardboard or sheetmetal panels.
NOTE:
Incorrect handling of tools
- Risk of damage to the body
→ Only use tools approved by Porsche.

→ Always ensure that the tool is seated correctly.

→ Protect the body and interior of the vehicle from damage with protective covers.

→ Cover delicate components with cardboard or sheetmetal panels.
Remove spacing block -1- between the roll-over bar and convertible-top support -2- (-arrow A-).
Position convertible top support -2- on the roll-over bar -arrow B- and secure with the three fastening screws -3- . Tightening torque → Tightening torque: 23 Nm (17 ftlb.)

Fig 3: Securing Convertible Top Support

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Place the belt reel -1- on the roll-over bar -arrow- , position it correctly and secure with the fastening screw -2- . Tightening torque → Tightening torque: 50 Nm (37 ftlb.)

Fig 4: Installing Belt Reel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.