Removing Convertible Top Frame
NOTE:
Hood frame not removed/installed correctly
- Risk of damage to paintwork on roll-over bar
→ Only install the hood in the vehicle together with the roll-over bar.
→ A second person is required during removal/installation.
Information
- The hood frame can be removed from the roll-over bar complete with all hood bows and with the two hood supports.
- Unscrew fastening screws -1- from the convertible top support -2- .
- Pull convertible top support -2- out by approx. 10 mm on both sides of the vehicle -arrow A- .
- Remove complete convertible top frame -3- with the two convertible top supports -2- by pulling it backwards -arrows B- off the roll-over bar -4- .