| Tie rod (ball-joint pin) on lever M12 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
75 Nm (56 ftlb.) |
|
|
| Aluminum tie rod to axial joint (lock nut) M14 x 1.5 |
Please note: When using special tool P9730 (socket wrench insert), observe the changed tightening torque! 50 Nm (37 ftlb.) at the lock nut corresponds to a setting of approx. 32.5 Nm (24 ftlb.) on the torque wrench. |
Tightening torque |
50 Nm (37 ftlb.) |
|
|
| Universal joint (steering shaft) to steering gear M8 x 35 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color! Replace fit bolt after each removal. |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Steering gear to cross member, M10 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color! Replace fastening screws following removal. |
Tightening torque |
70 Nm (52 ftlb.) |
|
|