LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2007 >> Boxster S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (42 - Rear Wheel Suspension, Drive Shafts -- 987-BOXSTER-CAYMAN) >> WM 422119 Removing And Installing Drive Shaft (Except CAYMAN Black Edition, CAYMAN S Black Edition, BOXSTER Black Edition, BOXSTER S "RS 60 SPYDER", BOXSTER S Black Edition, CAYMAN R) >> Installing Drive Shaft >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install support plate -A-  with the diagonal braces -B-  .

    → Installing Support Plate .

    Fig 1: Identifying Support Plates
    G09587568Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Fit rear wheel.

    → INSTALLING WHEEL

  3. Tighten the axle nut.

    → Tightening torque: 460 Nm (340 ftlb.) 

    Tighten axle nut (vehicle on ground) while operating the brake (2 fitters required).

scientia non olet · About LEMON Manuals