LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2007 >> Boxster S, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (40 - Front Wheel Suspension, Drive Shafts -- 987-BOXSTER-CAYMAN) >> WM 405055 Replacing Front Wheel Bearing Housing (All Models) >> Completing (Disassembling And Assembling) Wheel Bearing Housing

Completing (Disassembling And Assembling) Wheel Bearing Housing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disassemble old wheel bearing housing and fit reusable parts to the new wheel bearing housing (speed sensor, brake cover plate, lid for wheel bearing -3-  , fastening screws -2-  , wheel hub -1-  and tension bolt).

    The wheel bearing -4-  must be replaced.

    1. 1.1. Take off brake cover plate on the wheel bearing housing. Press wheel hub -1-  out of the wheel bearing housing (wheel bearing) → Removing Front Wheel Bearing 
    2. 1.2. Remove lid -3-  for wheel bearing on the wheel bearing housing (4 screws).
    3. 1.3. Press new wheel bearing -4-  into the new (heated) wheel bearing housing and complete the wheel bearing housing → Installing Front Wheel Bearing  .
    2. Fig 1: Identifying Wheel Bearing Housing Components
    G09587501Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals