LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2007 >> Boxster Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (42 - Rear Wheel Suspension, Drive Shafts -- 987-BOXSTER-CAYMAN) >> WM 420619 Removing And Installing Rear-Axle Cross Member (All Models) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Vehicle raised incorrectly
  • Danger of fatal injury and material damage should the vehicle fall down

→ Jack the vehicle at the prescribed jacking points.

  1. Jack and raise the vehicle at the prescribed jacking points.

    WM 4X00IN LIFTING THE VEHICLE (ALL MODELS)

    Information 

    • When raising the vehicle, take care to maintain access to the screws for the diagonal struts in the vicinity of the rear jacking points. 
  2. Remove rear underbody panelling.

    REMOVING COVER FOR REAR UNDERBODY

    Fig 1: Identifying Rear Underbody Components
    G09587537Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Remove support plate.

    Removing Support Plate 

    Fig 2: Identifying Support Plates
    G09587538Courtesy of PORSCHE CARS NORTH AMERICA, INC.