Installing Rear-Axle Cross Member

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information

After installing the rear-axle cross member, suspension alignment must be performed because the wheel alignment values of the rear axle might no longer be within the permitted tolerance range after removing and installing the rear-axle cross member.

Install rear-axle cross member.
1. 1.1. Fit rear-axle cross member -2- and screw in and tighten screws -1- (M10 x 45) on the rear-axle cross member -2- .
  Be careful with the bracket for the headlight levelling system.
  
  → Tightening torque: 65 Nm (48 ftlb.)
  
  Fig 1: Identifying Rear-Axle Cross Member And Mounting Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 1.2. Clip in electric plug connections on the rear-axle cross member.
  Clip electric plug connections -1- for the oxygen sensors on the rear-axle cross member at the left and right into the brackets.
  
  Fig 2: Removing Oxygen Sensor Connectors
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install heat protection cover at the right.
Fit heat protection cover -2- and screw on and tighten nuts -1- .

Fig 3: Identifying Heat Protection Cover And Mounting Nuts
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit restraining cables on rear-axle cross member.
Fit restraining cables into the rear-axle cross member -arrows- and screw on and tighten nuts -1- .

→ Tightening torque: 23 Nm (17 ftlb.)

Fig 4: Locating Restraining Cables On Rear-Axle Cross Member
Courtesy of PORSCHE CARS NORTH AMERICA, INC.