Table classification for suspension subframe repairs

Designation	Bore stroke measured from outer edge of sheet to tip of drill bit	Milling depth X	Thread depth Y	Bushing length	Note
Threaded bush 1 Diagonal brace screwed point	45 mm	9 mm	35 mm	20 mm	Measured from the outer edge of sheetmetalthread M10 x 1.5
Threaded bushing 2 screwed point, mounting for rear-axle side section	55 mm	30 mm	50 mm	20 mm	Measured from the outer edge of sheetmetalthread M10 x 1.5
Threaded bushing 3 screwed point, mounting for V-strut	55 mm	30 mm	50 mm	20 mm	Measured from outer edge of sheetthread M10
Threaded bushing 4 screwed point, mounting for engine mounting	35 mm	10 mm	27 mm	14 mm	Measured from the outer edge of sheetmetalthread M10 x 1.5
Threaded bushing 5 screwed point for front axle, rear	25 mm	1.8 mm	34 mm	26 mm	Measured from the outer edge of sheetmetalthread M14 x 1.5