Installing Underbody Cover

Installation Location:

Fig 1: Installation position of cover for rear underbody

Courtesy of PORSCHE OF NORTH AMERICA, INC.

Fig 2: Installing cover for rear underbody

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE: When pushing in the underbody cover, make sure the overlap is correct.

1. Insert cover for rear underbody -3- . See Fig 2.

2. Tighten fastening screws -1- . Tightening torque → Final tightening: 1.5 ftlb. +/-0.5 ftlb. See Fig 2.

3. Tighten fastening nuts -2- . Tightening torque → Final tightening: 1 ftlb. +/-0.5 ftlb. See Fig 2.

4. Tighten fastening nuts -4- . Tightening torque → Final tightening: 3.5 ftlb. +/-0.5 ftlb. See Fig 2.