Changing brake fluid

Fig 1: Cover over brake fluid reservoir

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Disengage and remove cover over brake fluid reservoir -B- . See Fig 1.

2. Fill reservoir up to the edge with new brake fluid.

Fig 2: Brakes: changing/bleeding brake fluid

Courtesy of PORSCHE OF NORTH AMERICA, INC.

3. Connect a bleeding device to the brake fluid reservoir. Switch on the bleeding device. Bleeding pressure → Changing/bleeding brake fluid: approx. 2.0 bar .

4. Continue changing the brake fluid at the brake calipers. Do so in the following sequence: rear right/rear left/front right/front left.

Use a transparent hose and a collecting bottle to check the escaping brake fluid accurately for cleanliness, lack of air bubbles and to determine the brake fluid used.

5. Open every bleeder valve until clear, bubble-free brake fluid emerges and until the corresponding change quantity per brake caliper is reached. Per brake caliper → Changing brake fluid (per wheel): approx. 250 cm3 .

Drain brake fluid on every brake caliper at both bleeder valves.

6. Tighten the bleeder valves to the stipulated tightening torque and remove the bleeder hoses.

7. Also drain off some brake fluid at the bleeder valve of the clutch slave cylinder.

Fig 3: Brake fluid level

Courtesy of PORSCHE OF NORTH AMERICA, INC.

8. Remove bleeding device from brake fluid reservoir and screw cap on. The brake fluid level in the brake fluid reservoir must be between the MIN and MAX markings once the vehicle has been filled and bled. Adjust the brake fluid level if necessary.

Fig 4: Cover over brake fluid reservoir

Courtesy of PORSCHE OF NORTH AMERICA, INC.

9. Place cover over brake fluid reservoir -B- . See Fig 4.