Convertible-top gap dimensions
NOTE:
- Set gap dimensions on the lids, doors and covers, or accessories in accordance with the gap specifications.
- Given a clearance in the opening that is too great or too small, the movable body or the accessories must be centerd accordingly.
- Ensure that the gaps do not taper or do not narrow at local points.
- The given values are guidelines which should be observed as far as possible.
- The guidelines apply to repair and assembly work.
- Use star gauges to measure the gap dimensions, Star gauges for body gap dimensions NR.127-1
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
| Windscreen frame to convertible top | Gap dimension A | 6.5 mm | +/-1 mm | ||
| Windscreen frame to convertible top | Convertible top only lowered | Gap dimension B | 1.5 mm |
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
| Windscreen frame to outer convertible top | Gap dimension A | 5.8 mm | +/-3 mm | ||
| Windscreen frame to outer convertible top | Convertible top only lowered | Gap dimension B | 1.5 mm |
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
| Convertible top to side window | Gap dimension A | 6.7 mm | |||
| Convertible top to side window | Gap dimension B | 6.6 mm |
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
| Convertible top to side panel | Gap dimension A | 5.9 mm | +3.25 mm | -2.9 mm |
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
| Convertible top to side convertible-top compartment lid | Gap dimension A | 5 mm | +2 mm | -3 mm |
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
| Convertible top to convertible-top compartment lid | Gap dimension A | 5 mm | +2 mm | -3 mm |