Removing pedal for foot-operated parking brake (FPB)

Fig 1: Bowden cable

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Loosen bowden cable for releasing the FPB at the dashboard (at the side). Pull the release lever slightly. Then, slide the bowden cable in the direction of travel and take the bowden cable sleeve out of the bracket.

2. Remove protective cover (two screws) over the foot-operated parking brake pedal.

3. Remove cover (protective grille) of foot-operated parking brake pedal.

4. Remove FPB switch.

NOTE:

Fix cables using tie-wraps to prevent damage while removing and inserting the FPB pedal.
The for the front brake cable cannot be removed and is not available as an individual part. Push the cable retainer back carefully during removal (Point 8). See Fig 2.

Fig 2: Front brake cable retainer

Courtesy of PORSCHE OF NORTH AMERICA, INC.

5. Lay the carpet aside. Remove fastening screws of FPB pedal (two M8 screws). Next remove the FPB pedal. The pedal must not be actuated (removal aid).

Fig 3: Pressing cable retainer back using a small screwdriver

Courtesy of PORSCHE OF NORTH AMERICA, INC.

6. Disengage front cable. To do this carefully press back the retaining lug using a small screwdriver. See Fig 3.