Installing design cover of cylinder bank 5 - 8

NOTE:

Place a cloth between secondary air pump and design cover to avoid scratching the cover.

Fig 1: Sliding design cover under secondary air pump

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Slide the design cover under the secondary air pump as illustrated.

Fig 2: Pressing down rubber mountings on bracket

Courtesy of PORSCHE OF NORTH AMERICA, INC.

2. Then press in the two rubber mountings on the bracket. The rubber mounts must be felt to engage.

Fig 3: Fastening screws of ignition coil cover

Courtesy of PORSCHE OF NORTH AMERICA, INC.

3. Tighten the four fastening screws on the ignition coils. → Tightening torque: 3.5 ftlb.