LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2006 >> Cayenne Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System >> 28 39 19 Removing and installing hall sender - as of MY 2003 (Cayenne S TIP, Cayenne S MAN, Cayenne Turbo, Cayenne Turbo S, Cayenne S TIO Titan) >> Removing hall sender >> Removing hall sender

Removing hall sender

NOTE:
  • The hall sensors are located behind the camshaft housing and point towards the intake system. 
NOTE: Replace all seals and O-rings.

1. Disconnect connector on hall sender. To do so, push the button and remove.

Fig 1: Fastening screw on hall sender
GP00009282Courtesy of PORSCHE OF NORTH AMERICA, INC.

2. Loosen the fastening screw on the hall sender. Use a socket wrench with 1/4 inch drive and a joint.

3. Pull the hall sender out of the camshaft housing.

scientia non olet · About LEMON Manuals