LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2006 >> Boxster Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (94 - Lights, Lamps, Switches, Exterior -- 987-BOXSTER-CAYMAN) >> WM 941519 Removing And Installing Main Headlight (All Models) >> Removing Main Headlight

Removing Main Headlight

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Risk of damage to headlights due to chafing and excessive temperatures.

Headlights must not be covered when they are switched on, e.g. by wing protector or film.

Switch off ignition.

  1. Release carpet at the side by unscrewing plastic nut -A, arrow-  .
    Fig 1: Releasing Carpet At Sides
    G09593405Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Pull rubber stopper -B-  out of the release opening.
    Fig 2: Pulling Rubber Stopper
    G09593406Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Place the socket wrench from the tool kit on the release axle.
  4. The toggle of the socket wrench should point horizontally to the rear.
  5. Turn the socket wrench through approx. 180° -A-  and leave it in position.
  6. The headlight is now unlocked and can be pulled forwards out of the wing.
  7. Turn the socket wrench back until it points vertically -B-  downwards.
  8. Fig 3: Releasing Headlight
    G09593407Courtesy of PORSCHE CARS NORTH AMERICA, INC.