Removing design cover of cylinder bank 5 - 8

NOTE:

Place a cloth between secondary air pump and design cover to avoid scratching the cover.

Fig 1: Fastening screws of ignition coil cover

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Unscrew the four fastening screws on the ignition coil cover.

Fig 2: Design cover of cylinder bank 5 -8

Courtesy of PORSCHE OF NORTH AMERICA, INC.

2. Remove design cover of cylinder bank 5 - 8. To do this, lift the cover slightly with both hands at the edge pointing towards the intake system until it is released from its holder.

Fig 3: Removing design cover

Courtesy of PORSCHE OF NORTH AMERICA, INC.

3. Lift the front of the design cover and remove it.