Installing headlight mounting
1. Push the mounting into the guides -Arrow A- . See Fig 1.
2. Push on connector -Arrow B- until the locking tab -C- is felt to engage. See Fig 1.
3. Place the washers -a, c- , rubber rings -b- and sleeves -D- on to the fastening screws in the order shown -Arrow- . See Fig 2.
NOTE:
- Turn the screws in the opposite direction when screwing the rear fastening screws in and out!
4. Screw in the rear fastening screws -1- but do not tighten them. See Fig 3.
5. Screw in the front fastening screws -2- but do not tighten them. See Fig 3.
6. Install the headlight. → 941519 Removing and installing main headlight - "installing" .