LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2005 >> Boxster S, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (46 - Brakes - Brake Mechanics -- 987-BOXSTER-CAYMAN) >> WM 460519 Removing And Installing Brake Pedal (Except CAYMAN Black Edition, CAYMAN S Black Edition, BOXSTER Black Edition, BOXSTER S Black Edition, CAYMAN R) >> Removing Clutch Pedal

Removing Clutch Pedal

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove lid and side trim panel on fuse box.

    Installation position: In driver's footwell at the left.

  2. Carefully pull off the connector from the clutch pedal switch (and interlock switch if necessary), see -arrows-  .
    Fig 1: Removing Clutch Pedal Switch Connector
    G09587775Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Remove device support.

    The device support is installed at the left next to the clutch pedal together with the vehicle electrical system control unit and relay carrier.

    1. 3.1. Remove relay carrier.
    2. 3.2. Remove vehicle electrical system control unit.
    3. 3.3. Remove device support.
  4. Secure clutch power spring.
    WARNING: Preloaded or pressurized components
    • Risk of squashing or bruising

    → Do not reach into the danger area.

    → Relieve the tension on components before starting work.

    → Secure components to prevent them from loosening suddenly.

    Secure clutch power spring using a cotter pin, for example. Press the clutch pedal lightly, then unclip and remove the clutch power spring.

  5. Remove clutch master cylinder -arrows-  and pin (master cylinder valve pushrod) - do not open the clutch system.
    Fig 2: Locating Clutch Master Cylinder
    G09587776Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Remove bracket for clutch power spring.

    Information 

    When removing the bracket for the clutch power spring, carefully guide the master cylinder valve pushrod past at the clutch pedal.

    (Also remove clutch pedal switch and interlock switch, if necessary) → Fig 3. Carefully move bracket for clutch power spring approximately 2 - 4 mm to the left -A-  . Carefully turn bracket for clutch power spring clockwise on the pedal bearing axle approximately 10 - 15 degrees -B-  . Remove bracket for clutch power spring to the left.

    Fig 3: Removing Clutch Power Spring Bracket
    G09587777Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals