LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2005 >> Boxster S (987) F6-3.2L >> Repair and Diagnosis >> Body and Frame >> Interior Moulding / Trim >> Trim Panel >> Service and Repair >> Procedures >> Removing and Installing Cover (Cold Air Bulkhead)

Removing and Installing Cover (Cold Air Bulkhead)



702219 Removing And Installing Cover (Cold Air Bulkhead)

Removing cover (cold air bulkhead)
1. Unscrew both plastic screws -1- and remove the cover downwards -arrows-.


Removing Cover:






Installing cover (cold air bulkhead)
1. Position the cover from below -arrows- and screw in with the two fastening screws -1-.


Installing Cover:




scientia non olet · About LEMON Manuals