Installing Brake Cables

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Install brake cables.
1. 1.1. Insert brake cables (at the underbody) into the housing or into the guide tubes (as of 2009 model) and press them in as far as they will go.
2. 1.2. Insert brake cables -1- into the guide tubes -5- at the wheel bearing housing and press them in as far as they will go -arrow- .
  
  Fig 1: Installing Brake Cables
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Engage brake cables at the expanding-lock.
1. 2.1. Fit expanding-lock -8- at the brake cable -1- and press the bolt -7- into the bore.
2. 2.2. Fit circlip -6- on the bolt -7- .
Fig 2: Identifying Brake Cables At Expanding-Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Engage brake cables at the handbrake lever.
Turn the lever -3- and engage brake cables -1- .

Fig 3: Identifying Brake Cables And Handbrake Lever
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install center console floor at the rear.
1. 4.1. Open the lid on the oddments tray.
2. 4.2. Fit center console floor at the rear -2- and secure with the fastening screws -1- .
Fig 4: Identifying Centre Console Floor Mounting Bolts
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install center console insert.
1. 5.1. Fit center console insert at the rear -1- (-arrow- ) and close the lid on the oddments tray.
Fig 5: Installing Centre Console Insert
Courtesy of PORSCHE CARS NORTH AMERICA, INC.