Removing stabilizer

Component overview - anti-roll bar → Component overview - anti-roll bar See Fig 1.

Fig 1: Component overview - anti-roll bar

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1 - Anti-roll bar

2 - Anti-roll-bar mount

3 - Clamp

4 - Fastening screws

5 - Connecting rod

6 - Fastening nut

7 - Fastening screw

Fig 2: Use rubber base between universal jack and wheel carrier

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Release connecting rod at anti-roll bar on left and right. To do this, use a suitable lift to raise the wheel carrier so far that the pin of the connecting rod can be pulled easily out of the anti-roll bar. Use a suitable lift with rubber base to prevent slipping. See Fig 2.

2. Undo the four fastening screws and remove the clamps.

Fig 3: Marking installation position of the anti-roll-bar and anti-roll-bar mount halves

Courtesy of PORSCHE OF NORTH AMERICA, INC.

3. Mark the installation position -arrow- of the anti-roll-bar mount halves with respect to the anti-roll bar with a paint marker. See Fig 3.

4. Carefully pull out the anti-roll bar.