LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2004 >> Cayenne S >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Wheel Suspension, Drive Shafts >> 42 21 37 Disassembling and assembling rear drive shaft - as of MY 2003 (All Models Except Cayenne S TIO Titan) >> Information >> Component overview

Component overview

Fig 1: Drive shaft components
GP00010197Courtesy of PORSCHE OF NORTH AMERICA, INC.
No. Designation Qty. Removal Installation
A Outer joint      
1 Hose clamp 69 x 10 1 Remove hose clamp using a hammer and chisel for example. Do not damage boot. Fit hose clamp with boot on the joint pin.
2 Boot 1 Remove boot from the shaft.  
3 Hose clamp 35 x 10 1 Remove hose clamp using a hammer and chisel, for example. Do not damage boot. Fit hose clamp on to the boot.
B Inner joint      
4 Hose clamp 35 x 10 1 Remove hose clamp using a hammer and chisel, for example. Do not damage boot. Fit hose clamp on to the boot.
5 Boot 1 Remove boot from the shaft.  
6 Clamp 69 x 10 1 Remove clamp using a hammer and chisel for example. Do not damage boot. Fit clamp with boot on the cap. The clamp lug must be positioned between two bores on the joint.
7 Cap 1   Seal the sealing faces with special sealant (refer to Spare Parts Catalogue). Make sure the bores are aligned during positioning.
8 Joint 1 Press joint off the drive shaft. Fit the joint as far as it will go on to the drive shaft using a hammer and mandrel. Make sure the bores are aligned with the bores on the cap.
9 Circlip 28 x 1.5 1 Remove circlip carefully with a pliers. (1) Ensure that the circlip is seated correctly.
10 Closure cap 1 Remove cap. Use two cheese-head bolts to center the cap. Ensure correct seating. Seal the sealing faces with special sealant (refer to Spare Parts Catalogue).
(1)
scientia non olet · About LEMON Manuals