Installing the current distributor

NOTE:

The following spare parts must be installed again:
1. Hexagon nut M 6, 7 pieces
2. Hexagon nut M 8, 2 pieces
3. Service label, red Depending on condition, flange seal current distributor/firewall
4. Tie-wraps

Fig 1: Installing Current Distributor

G03091758

Courtesy of PORSCHE OF NORTH AMERICA, INC.

CURRENT DISTRIBUTOR INSTALLATION INSTRUCTIONS

No.	Procedure	Instructions
1	Connecting the connection lines	Connect the connection lines -C--B--9-
2	Closing and sealing the current distributor	Close the cover until both locking elements -arrow-8-red-
3	Installing the current distributor	Check the flange seal between the current distributor and the firewall for damage and replace, if necessary. Push the current distributor -A-direction of the arrow-A-6-7-
4	Screwing the current distributor tight	Tighten both hexagon nuts -3-2-1-
5	Cover in passenger's footwell	Position the cover -5-4-
	Connecting the battery	Refer to WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
	Installing the cowl panel cover	Refer to REMOVING AND INSTALLING COWL PANEL COVER .