LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2004 >> 911 GT2 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Hydraulic - 911 Turbo (996) >> Removing and installing brake master cylinder >> Installation

Removing and installing brake master cylinder: Installation

  1. Install in reverse order.
  2. Bleed the brakes. See BLEEDING BRAKES (VEHICLE WITH PSM) 
    NOTE:
    • First bleed brakes as usual!
    • Do not carry out booster pump activation with the Porsche System Tester 2 until after this has been done (after conventional bleeding) as otherwise damage to the booster pump can occur!
    • To bleed at front on right with running booster pump the bleeding device remains connected (switched on)! Bleeding pressure approximately 2.0 bar!
  3. Carry out a function check of the brakes.
scientia non olet · About LEMON Manuals