Installing covering for the front backrest frame

Fig 1: Installing Covering For Front Backrest Frame - As Of MY 1997 To 2002 (1 Of 2)

Courtesy of PORSCHE OF NORTH AMERICA, INC.

PROCEDURE FOR INSTALLING COVERING FOR FRONT BACKREST FRAME - AS OF MY 1997 TO 2002 (1 OF 3)

No.	Procedure	Instructions
1	Positioning foam part	Position foam part on the backrest frame.
2	Installing backrest covering	Fit the backrest covering onto the backrest frame. Press the covering bead -7-8-
3	Fitting the backrest covering at rear	Press the connection of the backrest covering into the backrest shell at the rear-9-
4	Folding over the side bolsters	Screw in the connection -11-direction of arrow-

Fig 2: Installing Covering For Front Backrest Frame - As Of MY 1997 To 2002 (2 Of 2)

Courtesy of PORSCHE OF NORTH AMERICA, INC.

PROCEDURE FOR INSTALLING COVERING FOR FRONT BACKREST FRAME - AS OF MY 1997 TO 2002 (2 OF 3)

No.	Procedure	Instructions
5a	Closing side bolster closure, new status	Engage the side bolster closure -10-
5b	Closing side bolster closure, old status	Join both side bolster closures -10-
6	Installing clothes hook	Position the clothes hook -6-5-
7	Installing release lever	Inset the collar -4-3 -
8	Installing backrest cover Installing the backrest centre strip	Insert the side backrest cover -2-1- See INSTALLING THE BACKREST CENTRE STRIP

CAUTION:

Danger of material damage if excessive heat is applied!
If creases form, only short partial warming with the hot-air gun is permissible. The hot-air temperature of approx. 50 degrees Celsius (122 Fahrenheit) must always be observed.

PROCEDURE FOR INSTALLING COVERING FOR FRONT BACKREST FRAME - AS OF MY 1997 TO 2002 (3 OF 3)

No.	Procedure	Instructions
	Remedying creases in the backrest cover	If creases form in the areas of the backrest cover, heat them partially with the hot-air gun.