Total mileage: Notes

It is possible to code the total mileage under this menu item after replacing the instrument cluster.

1. Connect PST 2 and switch on ignition.
2. Select vehicle type 911 (996) and the instrument cluster control module and press the key ">>"
3. Select the menu item Transponder key  and press the key ">>".
4. You are requested to enter the Vehicle Ident. No.  .
5. Enter Vehicle Ident. No. or accept with the key ">>", check the entry and press key "F7".
6. Observe the instructions of the diagnosis tester, enter the total mileage with the tabulator key, check and then press the "F8" key to code the entered total mileage.

The total mileage can also be read out from the old instrument cluster under the menu item "Control module replacement" and can be transferred into the new instrument cluster if the old replacement instrument is still functional and if it is possible to establish communication with the PST 2.