LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2004 >> 911 GT2 >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Equipment - 911 Turbo (996) >> Removing and installing center console (front section)

Removing and installing center console (front section)

Fig 1: Identifying Center Console (Front Section)
G03094557Courtesy of PORSCHE OF NORTH AMERICA, INC.
Fig 2: Identifying Center Console (Front Section) Components
G03094558Courtesy of PORSCHE OF NORTH AMERICA, INC.
CENTER CONSOLE (FRONT SECTION) REMOVAL/INSTALLATION

No. Designation Qty. Removal Installation
1 Cover, front left 1 Unclip the front left cover -1-  Position the front cover -1-15-3- 
2 Cover, front right 1 Unclip the front right cover -2-  Position the front cover -2-15-3- 
3 Clip 10   Inspect clip -3- 
4 Cover cap (telephone trim panel) 1    
5 Fastening screw 9    
6 Telephone trim panel 1 Insert a wire into the hole of the cover cap -4-5-8-  Insert the locking tabs of the telephone trim panel into the front cover -8-5-2.3 N.m (1.5 ftlb.)--4- 
7 Installation frame for (telephone handset) 1    
8 Cover, front left (telephone carrier) 1 Unscrew fastening screws -5-  Position cover at the centre console at the front, clip in at the side and fasten with the fastening screws -5-2.3 N.m (1.5 ftlb.) 
9 Adapter 1 Unscrew fastening screws -5-  Position the adapter at the centre console at the front -9-5-2.3 N.m (1.5 ftlb.) 
10 Combi-single CD drive for navigation 1 See:
Refer to REMOVING AND INSTALLING NAVIGATION UNIT
 
11 Heating/air-conditioning control 1 Refer to REMOVING AND INSTALLING THE HEATING/AIR-CONDITIONING CONTROL  
12 Front trim 1 Unclip the front trim -12-  Connect the electrical connection, position the front trim -12-15- 
13 Cover, left 1 Unclip the left cover -13-  Position the right cover -13-3- 
14 Cover, right 1 Unclip the right cover -14-  Position the right cover -14-3- 
15 Centre console (front section) 1 Undo fastening screws -5-15-  Position the front of the centre console -15-18-5- 
16 Plug-in nut 4   Inspect and replace if necessary.
17 Collar nut 4   Tightening torque: -10 N.m (7.5 ftlb.)- 
18 Holder 1