Removing front brake pads

The core of the warning contact line must not be left exposed! Worn insulation is not significant!

If necessary, remove a little brake fluid from the expansion tank by suction to prevent overflow when the disc brake pad is pushed back!

Fig 1: Holding down expanding springs with a screwdriver

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Remove fastening screw at retainer pin. Then screw in auxiliary screw M8. Hold down expanding springs with a screwdriver -see illustration-  and remove retainer pin. See Fig 1.

2. Remove warning contact line from brake caliper and expanding spring. Remove warning contacts from the brake disc pads.

Fig 2: Pushing pads back using piston resetting fixture

Courtesy of PORSCHE OF NORTH AMERICA, INC.

3. Place piston resetting fixture (replaces P83) NR.144 , see Workshop Equipment Manual, Chapter 2.4, on brake caliper between the disc brake pads and push the pads back evenly -arrows-  . See Fig 2.

Fig 3: Removing disc brake pads

Courtesy of PORSCHE OF NORTH AMERICA, INC.

4. Remove disc brake pads.