Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Cayenne S, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All (Both Sides) | 2.0 | B | ||
| Front,Both Sides. | 1.2 | 0.9 | B | |
| Rear,Both Sides. | 1.0 | 0.7 | B | |
| Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed Brake System. | ||||
| Each Additional | 0.2 | B | ||
| One | 1.1 | B | ||
| Combination Procedure: BRAKE PAD WEAR SENSOR: Replace: | ||||
| Front,Both | 0.1 | B | ||
| Rear,Both | 0.1 | B | ||
| Combination Procedure: CALIPER: Replace: Includes: Bleed Brake System. | ||||
| One | 1.1 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove & Install or Remove & Replace: | ||||
| Front,Each | 0.2 | B | ||
| Rear,Each | 0.5 | B | ||
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides | 1.4 | B | ||
| One Side | 0.6 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| S,Turbo, Rear,Both Sides | 5.3 | B | ||
| S,Turbo, Rear,One Side | 4.4 | B | ||
| Front,Both Sides | 3.6 | B | ||
| Front,One Side | 1.8 | B | ||