| Location |
Explanation |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Threaded connection securing stabilizer to rear-axle suspension subframe, M10 x 25 |
|
Tightening torque |
37 ftlb. |
|
|
| Threaded connection for suspension/stabilizer, M12 x 1.5 |
Replace screws and fastening nuts after removal. |
Tightening torque |
74 ftlb. |
|
|
| Threaded connection securing suspension/stabilizer to wheel carrier/shock absorber strut, M12 x 1.5 x 120 |
Replace screws and fastening nuts after removal. |
Tightening torque |
67 ftlb. |
+90 degrees |
|
| Threaded connection for union nut |
|
Tightening torque |
10.5 ftlb. |
+0.5 ftlb. |
-0.5 ftlb. |
| Threaded connection for disconnection points |
|
Tightening torque |
10.5 ftlb. |
+0.5 ftlb. |
-0.5 ftlb. |
| Threaded connection securing line connections to left actuator (in direction of travel) |
|
Tightening torque |
30 ftlb. |
+1.5 ftlb. |
-1.5 ftlb. |
| Threaded connection securing line connections to right actuator (in direction of travel) |
|
Tightening torque |
15 ftlb. |
+1.5 ftlb. |
-1.5 ftlb. |
| Threaded connection securing sensor to actuator |
Replace screws and fastening nuts after removal. |
Tightening torque |
2 ftlb. |
|
|
| Bleeder valve screw connection |
|
Tightening torque |
5 ftlb. |
|
|