Removing rear disc brake pads

The core of the warning contact line must not be left exposed! Worn insulation is not significant!

If necessary, remove a little brake fluid from the expansion tank by suction to prevent overflow when the disc brake pad is pushed back!

Fig 1: Removing retaining pin

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Remove lock (securing clip) -top arrow-  from retaining pin and remove retaining pin -direction arrow-  inwards. See Fig 1.

2. Remove warning contact line from brake caliper and expanding spring. Remove warning contacts from the brake disc pads.

3. Remove expanding spring.

Fig 2: Pushing pads back using piston resetting fixture

Courtesy of PORSCHE OF NORTH AMERICA, INC.

4. Place piston resetting fixture (replaces P83) NR.144 , see Workshop Equipment Manual, Chapter 2.4, on brake caliper between the disc brake pads and push the pads back evenly -direction arrows-  . See Fig 2.

5. Remove disc brake pads.