Further to 4a: Fine balancing of the front wheels

NOTE:

Due to the all-wheel drive, all four wheels must be raised and must be able to turn freely.
Ensure that the take-up fork of the measuring support does not damage any parts!

Position measuring support at the front axle on the right and left. Before the first measuring run, re-check to ensure that slipping from the measuring support is not possible!
Centre the sensitivity control. Carry out a measuring run.
Affix balancing weight if necessary. Then perform a check run. If the result is unacceptable (precondition: the work was performed properly), calibrate the finish balancer. This means that the sensitivity control must be adapted to the actual situation.
If the balancing result is still not quite right even after calibration (for example, 5 g), change the balancing weight according to the balance correction table (balance correction schematic) and thereby eliminate the residual imbalance.