Further to 3: Mounting the wheel on the vehicle

NOTE:

Never use an impact bolter!
Observe grease specification and information on the two-piece wheel bolt! This is described in the section describing wheel removal and installation (mounting wheel on the vehicle). See REMOVING AND INSTALLING THE WHEEL - TURBO AND GT2 .

Mount wheel with suitable commercially available tools.
If necessary, mark the position of the wheel on the wheel hub before removing the wheel. Use a piece of adhesive tape to mark the wheel and the wheel hub. This will preserve any optimum balancing result previously achieved by means of fine balancing (finish balancers), even after the wheel is re-mounted.
Screw in wheel bolts by hand and then tighten evenly. Start at the top when tightening. Always observe the specified tightening torque of 130 Nm (96 ft.lb).
Prescribed tire pressure.