LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Exterior Lights, Lamps, Switches - 911 CARRERA (996)) >> Removing and installing rear angle sensor for automatic headlight beam adjustment >> Removal

Removing and installing rear angle sensor for automatic headlight beam adjustment: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Hold the rotary lever of the linkage with the second open-ended wrench and detach. Push back the rubber cover over the electrical plug connection and detach the plug connection from the angle sensor.
    2. Fig 1: Detaching Plug Connection From Rear Angle Sensor
    G03063666Courtesy of PORSCHE OF NORTH AMERICA, INC.
  2. Detach the retaining bracket for the angle sensor, combination wire and brake line from the body.
  3. Detach the angle sensor from the retaining bracket and remove it.
scientia non olet · About LEMON Manuals