LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Exterior Lights, Lamps, Switches - 911 CARRERA (996)) >> Removing and installing ignition unit for gas discharge lamp >> Removal

Removing and installing ignition unit for gas discharge lamp: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch off the light. Release the headlight housing and pull out forwards slightly.
  2. Disconnect the electrical plug connection of the automatic headlight beam adjustment and remove the headlight housing.
  3. Release and open the cover with control module. Unscrew the electrical plug connection on the gas discharge lamp (bayonet lock).
  4. Undo the two fastening screws on the ignition unit and remove the ignition unit. Pull off electrical plug connection.
    Fig 1: Undoing Fastening Screws & Removing Ignition Unit For Gas Discharge Lamp
    G03063656Courtesy of PORSCHE OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals